Reset cisco 2950 switch without password

#RESET CISCO 2950 SWITCH WITHOUT PASSWORD SOFTWARE#
#RESET CISCO 2950 SWITCH WITHOUT PASSWORD PASSWORD#

Subnet mask for this interface :255.255.255.0 NOTE: this is the IP we are going to use to connect to this switch using our broswer for the web interface Management network from the above interface summary: FastEthernet0/24 (Or set whatever Interface you want)Р”В¬onfigure IP on this interface? : yes

#RESET CISCO 2950 SWITCH WITHOUT PASSWORD PASSWORD#

The virtual terminal password is used to protectР”Р„ccess to the router over a network interface.Р”В®nter virtual terminal password(enter whatever you want your password to be)Р”В®nter interface name used to connect to the

#RESET CISCO 2950 SWITCH WITHOUT PASSWORD SOFTWARE#

The enable password is used when you do not specify anР”В®nable secret password, with some older software versions, andР”В®nter enable password(enter whatever you want your enable password to be) This password, afterР”В®ntered, becomes encrypted in the configuration.Р”В®nter enable secret : (enter whatever you want your secret password to be) The enable secret is a password used to protect access to Would you like to enter basic management setup? : noР”Р‡irst, would you like to see the current interface summary? : noР”В®nter host name (enter whatever you want to name your switch) Now you are back to the promp and enter this command:Р”В¬ontinue with configuration dialog? : no

Now that the flash OIS has been initialized, select 'boot' from the main and hit enter on your keyboard, the switch will start to load the OS until you get to a message that says: Press RETURN to get started!

Parameter Block Filesystem (pb:) installed, fsid: 4 Now the setting has been set to factory defaults:Р”Р‡lashfs: 0 orphaned files, 0 orphaned directoriesР”В«oot Sector Filesystem (bs:) installed, fsid: 3 The flash filesystem, and finish loading the operatingР”В®nter: flash_init and hit Return on your keyboardР”Р„fter you select flash_init you will see a message: Initializing Flash. The system has been interrupted prior to initializing theР”Р‡lash filesystem. Ok now that we have connected to the switch using hyperterminal and you are at the main flash menu: you should see something that looks like this:Р”В 0:00:17: %SYS-5-CONFIG_I: Configured from memory by consoleР”В 0:00:17: %SYS-5-RESTART: System restarted -Р”В¬isco Internetwork Operating System Software

Reset cisco 2950 switch without password